ER50 collets hold shanks from 4 to 34 mm. Each collet covers 2 mm: pick the one whose range includes the shank diameter.
CLAMPING RANGE4–34 mmstandard maximum, DIN 6499
STEP2 mmrange of each collet
COLLET BODYØ 52 × 60 mmdiameter × length
TAPER8°ISO 15488
Sizes in the series
ER50 collets are marked with their range, largest to smallest: collet 34–32 holds shanks from 32 to 34 mm.
6–4
8–6
10–8
12–10
14–12
16–14
18–16
20–18
22–20
24–22
26–24
28–26
30–28
32–30
34–32
How to choose the collet
Take the collet whose range includes the shank diameter, ideally close to the collet's maximum: the grip is longer and runout lower. A 20 mm shank in ER50 needs collet 20–18.
Beyond the standard 34 mm, some makers offer special ER50 collets up to 36 mm.
Clamping and care
Snap the collet into the nut before fitting it to the chuck, then tighten with the wrench and torque given by the chuck maker. Keep collet and taper clean: one chip or dirty oil film is enough to lose runout.
Clamping ranges to DIN 6499 / ISO 15488 and the REGO-FIX ER system catalogue; body dimensions as in published ER charts. The collet maker's catalogue is what counts.
Type the shank diameter: see which collet fits, in every ER size.
What problem it solved, how much time it saves you, what is missing. We read everything. We only publish with your permission, and only the way you choose.
Thank you. We have it: if you allowed publishing, we will write to you to confirm before it goes online.